EP CLEAR -444 is a two component epoxy based colourless liquid coating. Its water white appearance provides high gloss and smooth surface when used as a finish coat over epoxy painting treatments.


  • Being two component pre packed units it is easy to use.
  • Can be sprayed, brushed or used with a roller.
  • It attains high gloss and smooth surface.
  • It is colourless.
  • It acts as a protective barrier over treated surface.
  • Good scratch and abrasion resistance.


Can be used over a variety of surfaces like wood, concrete, metal, stone, all kinds of household articles, furniture, paraquet wooden floors, bathroom doors, stone artefacts, metal objects, ceramic tiles, etc. It can be used on industrial floors over epoxy treatments as a finish coat to provide high gloss and hygienic look.


The surface preparation is of prime importance. The surface must be firm and dry clean from the, loose dirt, laitance, grease, oil, rust and other contaminants prior to application.


Mix both Resin and Hardner as supplied thoroughly. The mixed contents can be applied by spray, brush or roller. Minimum two coats to be applied at an interval of 3-4 hours between each coat. Inter coating interval should not exceed more than 8 hours. Do not leave mixed material over night as it will jell.


Clean all tools, equipments immediately with EP THIN 200 only.


Store in cool, dry place away from direct sunlight.


Do not apply on wet surfaces or on freshly laid concrete. Do not split packs. Working areas should be well ventilated as the vapours of solvent should not be inhaled for long duration. Smoking should not be permitted during application and away from open flames, lights etc.


1, 4, 20 litres

EP CLEAR-444 (Epoxy Clear Lacquer)

Color Colourless Liquid
Appearance Pale Yellow
Finish High Gloss and Smooth
Mixing Ratio 1:1 By Volume
Pot Life of @ 30°C 8 to 10 hours
Drying Time @ 30°C Surface Dry 2 to 3 Hours
Hard Dry 8 to 10 hrs
Full Cure 7 Days
Dry Film Thickness 40-50 microns per coat
Scratch Hardness Good
Coverage Porous 100-125 sq.ft./Ltr
Non Porous 150-175 sq.ft./Ltr
Flash Point Above 30°C